For contact , remarks , info or suggestions:
Important notice:
All mentioned names and rights belong to the owner.
Disclaimer: The opinions expressed here represent the opinions of the author and not necessarily those of www.cardiagnostics.be. All data and information provided in this article is for informational purposes only. www.cardiagnostics.be makes no representations as to accuracy, completeness, suitability, or validity of any information in this article or respondents comments and will not be liable for any errors, omissions, or delays in this information or any losses, injuries, or damages arising from its display or use. All information is provided on an as-is basis.
NISSAN KEY FOB PROGRAMMING
SYSTEM DESCRIPTION
The Central Door locking is controlled by the Multi-Remote Control system which
controls
the door locking, door super locking and hazard reminder. When the doors are
locked and
unlocked the unit flashes the hazard lights once for lock and twice for unlock.
A maximum of four remote controls are allowed to be programmed.
ALMERA
ALMERA TINO
PRIMERA
MAXIMA
MICRA
SERENA
VANETTE CARGO
TERANO II
Ensure all the doors have been unlocked, either by using a good transponder key
or remote
control key.
Procedure
1. Turn the ignition switch from Position 0 to ON 6 times within 10
seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
lights twice.
4. Press and HOLD the unlock button on the remote key.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 key’s.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all remote key’s
for operation.
NOTE : The programming mode will stop when either the
ignition is switch ON, 4 keys
have been programmed or no input signal either from the switch or
remote keys has been received
for 120 seconds.
No, the remote control operates the CDL & alarm
systems so is independant from the immobiliser.
The immobiliser is controlled by way of a carbon transponder chip located in
the plastic part of the key blade of which the remote control fits.
NATS IMMOBILISER UNIT
The NATS immobiliser unit, is normally mounted next to the ignition switch or
behind the
fascia area. The unit is sometimes also fitted with a dongle unit, and is
fitted on right hand
drive European vehicles for extra security.
The NATS immobiliser controls signals to the Engine Control Module (ECM) which
inhibit
starting.
On later systems there is also an input from the Audio system, which if
disconnected inhibits
the starting of the vehicle.
NATS SECURITY INDICATOR
The security LED is normally mounted in the dashboard
area and indicates the status of the system.
When a problem is detected, the LED will indicate the fault when the IGN is ON
or in accessory position.